Xerox DocuColor 7000 EN - Manual (Page 143)

DocuColor 8000/7000 Operator Manual 4-13
4. Problem solving
6. The Fuser area is on the right hand side of the Paper
Transport module. Lift handle 4c on the right hand side and
pull to open.
7. Lift up handle 4d until it stops and clear any jammed paper.
Rotate knob 4e in the direction of the arrow on the knob to
clear any paper that is caught.
NOTE: Occasionally a sheet of paper wraps around the heat
roll. (The heat roll is visible when handle 4d is up). DO NOT
attempt to remove this sheet of paper because the stripper
fingers may be damaged if you attempt this procedure. Call
your Xerox service representative to remove this piece of
paper.
Reposition green handle 4d and close area 4c. Ensure these
are firmly in place.
8. Grasp handle 4 and slowly push in the Paper Transport until it
stops. Turn the handle in the direction of the arrow to lock the
module in place.
9. Close the Right and Left Front Doors.
10. Follow the instructions on the UI to restart your print job.