Xantrex Technology GT3.0 - Manual (Page 82)

Monitoring the Inverter
5–6 975-0131-01-01
These message screens are common to all GT Inverter systems, no matter how
many units are installed. If you continue to tap the unit, then the LCD will
continue to cycle through all of the available offline mode screens.
Additional Offline
messages for
multiple unit
systems Multiple unit systems in offline mode display all of the message screens shown in
Table 5-6, plus the additional screens shown in Table 5-7. These additional
screens are displayed following the “Time Online” screen.
These screens are only displayed on multiple unit GT Inverter systems with
communications cabling properly installed. If you continue to tap the unit, then
the LCD continues to cycle through all of the available offline mode screens.
Fault Mode
When a fault state is detected, the appropriate fault message appears on the front
panel display at the next screen refresh (i.e., within 2 seconds). The GT Inverter
fault message screens are shown in Table 5-8.
Table 5-6 Offline Mode Screens for All GT Inverter Units
Tap Display*
* In a multiple unit system with communications cables properly installed, the
system values displayed are for the entire system. Time online is for the local
inverter.
Description
1st time
Inverter
Offline
LCD back light turns on for better readability
and default Offline Mode screen is displayed.
2nd time
System 0W
Today 2.50kWh
Power being produced by the system now.
Cumulative energy produced by the system
today.
3rd time
System Lifetime
305kWh
Lifetime energy produced by the system.
4th time
Time Online
hh:mm:ss
Total time that the system was online today, in
hours (hh), minutes (mm) and seconds (ss).
Table 5-7 Additional Offline Mode Screens for Each GT Inverter Unit in a
Multiple Unit System
Tap Display Description
5th time
Unit 0W
Today 1.25kWh
Power being produced by this unit now.
Cumulative energy produced by this unit today.
6th time
Unit Lifetime
150kWh
Lifetime energy produced by this unit.