Westell Technologies 2200 - Manual (Page 11)

030-300354 Rev. B 7 July 2003
Section 5-Installing the Hardware
Westell Dual Connect NAT Router User Guide
5.4.2 Router Installation via USB
NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install
the Router via Ethernet connection. See section 5.4.1.
Refer to Figure 2.
1. Connect the power supply cord to the power connector marked
~
on the rear panel of the Router. Plug the
other end of the power supply into an AC wall socket.
2. Connect the DSL phone cable from the connector marked on the rear panel of the Router to the DSL-
equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must
use the phone cord that was provided with the Router kit.
3. Connect the USB cable from the USB connector marked on the rear panel of the Router to the USB port
on the PC.
Congratulations! You have completed the USB hardware installation for your Dual Connect NAT Router. You must
now go to Section 6 to begin the USB driver software installation.
Figure 2. Connection via USB
12V
!