Western Telematic RPC-4840N - Manual (Page 37)

6.6. Other Commands
6.6.1. Login as Different User
The /R command is used to re-login using a different password.
When invoked, the RPC will display the password prompt,
allowing the user to enter a different password in order to access
the other circuit or System Level command functions. The /R
command is typically used to switch from User Mode to
System Mode.
The /R command is available in both System Mode and User
Mode. To login as a different user, type /R, press [Enter], and
then key in a different valid password at the prompt. To
suppress the "Sure?" prompt, type /R,Y [Enter].
6.6.2. Reset Network Port
The /T command is used to reinitialize the RPC Network card.
The /T command is not available in User Mode. To reset the
Network Port, type /T and press [Enter]. To suppress the
"Sure?" prompt, type /T,Y [Enter].
Note: The /T command can only be issued via the
Console Port or Modem Port. The /T command
cannot be invoked via the Network Port.
6.6.3. Exit / Disconnect
To exit from the RPC Command Mode and discontinue
connection to the unit, type /X and press [Enter]. The RPC will
display the "DISCONNECT" message. To suppress the "Sure?"
prompt, type /X,Y [Enter].
Note: Only one port may access the command
mode at any given time. In order to allow access to
the RPC unit via other ports, always exit from the
command mode when you are finished
communicating with the unit. For more information,
please refer to Section 6.7.
6-7
Operation