Western Telematic RPC-4840N - Manual (Page 22)

5.3. Command/Menu Conventions
When invoking RPC-4840N commands and selecting items from
configuration menus, note the following:
· To display the Help Screen, type /H [Enter].
· All RPC commands can be invoked at the RPC> command
prompt, or from the General Parameters Menu, Port
Parameters Menus or Network Parameters Menu.
· RPC commands are not case sensitive.
· All commands are invoked by pressing [Enter].
· To select an item from a menu, key in the number for the
item and press [Enter]. To exit from a menu, press [Esc] at
any time. Parameters defined up to that point will be saved.
· The ",Y" option can temporarily suppress the "Sure?"
confirmation prompt. The ",Y" option is entered at the end
of the command line, immediately following the command
or argument. For example, to reset the network port without
displaying the "Sure?" prompt, type /T,Y [Enter].
5.4. Defining General Parameters
When the "RPC>" prompt appears, type /G [Enter] to display
the General Parameters menu (Figure 5.3). Note that this menu
is not available in User Mode. The General Parameters menu
offers the following options:
1. System Password: (Up to 16 characters, case-sensitive)
When the System Password is defined, the RPC will
display a prompt before allowing access to command
mode. If the System Password is entered, the RPC will
start-up in System Mode. To define the System Password,
type 1 and press [Enter]. (Default = undefined).
Note: If the System Password is not defined, the
password prompt will not be displayed, and the RPC
will always start-up in System Mode.
2. Site ID: Defines a text string (up to 32 characters) that is
often used to indicate the installation site. To define the
Site ID, type 2 and press [Enter]. (Default = undefined).
5-4
RPC-4840N Remote Power Controller; User's Guide