Western Telematic RPC-4840N User Manual
Page 12
4. Configure Network Port: In order to communicate with
the RPC-4840N via the Network Port, you must first
define the IP Address, Subnet Mask, and Gateway
Address. At the RPC> command prompt, type /N and
press [Enter] to display the Network Parameters menu.
a) Settings for network parameters will depend on the
configuration of your individual network. Please
contact your network administrator to determine
appropriate settings for the IP Address, Subnet Mask,
and Gateway Address.
b) To assign network parameters, key in the number for
the desired parameter, press [Enter], and then follow
the instructions in the resulting submenu. For
example, to define the IP Address, type 1 and
press [Enter].
3-2
RPC-4840N Remote Power Controller; User's Guide
Remote Power Controller v2.0
Site: WESTERN TELEMATIC, INC.
Commands:
Display
/H
Display this help screen
/S[P]
Display Ckt. Status, [P] with passwords
Configuration
/G
View/Set General Parameters
/P [n]
View/Set Ckt. Parameters
/N
View/Set Network Parameters
/DL
Download configuration to file
Control
+------------------------------------+
/D
Set Ckts. to default setting | [n] = optional Ckt. name or number |
/Boot
|
/On
Turn On Ckt. n
| n+n = Ckt. n and Ckt. n
|
/Off
Turn Off Ckt. n
| n:n = Ckt. n through Ckt. n
|
/T
Reset Network Interface
| * = all Ckts. with access
|
/R
Relogin as different user
+------------------------------------+
/X
Exit/Disconnect
RPC>
Figure 3.1: The System Help Screen