VIEWSONIC XGA LCD PROJECTOR pjl9371 - Manual (Page 36)

PJL9371 ViewSonic 3
INPUT menu
INPUT menu
From the INPUT menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor (or the ENTER) button to execute
the item. Then perform it according to the following
table.
Item Description
PROGRESSIVE
Using the ▲/▼ cursor buttons switches the progress mode.
TV ó FILM ó OFF
• This function is performed only for a video signal, s-video signal or
component video signal of 480i@60 or 576i@50.
• When the TV or the FILM is selected, the screen image will be
sharp. The FILM adapts to the 2-3 Pull-Down conversion system.
But these may cause a certain defect (for example, jagged line) of
the picture for a quick moving object. In such a case, please select
the OFF, even though the screen image may lose sharpness.
VIDEO NR
Using the ▲/▼ cursor buttons switches the noise reduction mode.
HIGH ó MID ó LOW
• This function is performed only for a video signal, s-video signal or
component video signal of 480i@60 or 576i@50.
• When this function is excessive, it may cause a certain
degradation of the picture.
COLOR SPACE
Using the ▲/▼ cursor buttons switches the mode for color space.
AUTO ó RGB ó SMPTE240 ó REC709 ó REC601
• This item can be selected only for a computer signal or a
component video signal (except SCART RGB).
• The AUTO mode automatically selects the optimum mode.
• The AUTO operation may not work well at some signals. In such a
case, it might be good to select a suitable mode except the AUTO.
COMPONENT
Using the ▲/▼ cursor buttons switches the function of the
COMPONENT (Y, Cb/Pb, Cr/Pr) port.
COMPONENT ó SCART RGB
When the SCART RGB is selected, the COMPONENT (Y, Cb/Pb,
Cr/Pr) and the VIDEO ports will function as a SCART RGB port.
A SCART adapter or SCART cable is required for a SCART RGB
input to the projector. For details, contact your dealer.
(continued on next page)