VocoPro DTX-9909K - Manual (Page 46)

46
Problem Cause Remedy
Previously preset stations can no longer
be tuned in.
The desired AM station cannot be
tuned in with the automatic tuning
method
There are continuous crackling and
hissing noises
There are buzzing and whining noises
The remote control does not function
properly
• The DTX-9909K has been discon-
nected for a long period of time
• The signal is weak of the antenna
connection is loose
• These noises are caused by lightning,
fl uorescent lamps, motors, thermo-
stats and other electric equipment
• A TV set is being used nearby
• Wrong distance or angle
• Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.)
is striking the remote control sensor on
the DTX-9909K
• The batteries are weak
• No batteries are installed or they are
installed in the wrong polar direction
• Preset the stations again
• Tighten the AM loop antenna connec-
tion and reposition it for better recep-
tion
• Use the manual tuning method
• Use an outdoor antenna and a ground
wire
• Move the DTX-9909K away from the
TV
• The remote control will function within
a maximum range of 20’ (6m) and at
no more than a 30° angle from the
DTX-9909K’s front panel
• Reposition the DTX-9909K
• Replace all of the batteries
• Install the batteries into the remote
control. Be sure to match the + and
-- ends of each battery to the symbols
shown in the remote control’s battery
compartment
Troubleshooting cont.