VocoPro DTX-9909K - Manual (Page 37)

37
Speaker Settings Menu
In order to adjust the speaker settings, the DTX-9909K eaker settings, the DTX eaker settings, the DTX
must be in Music Mode. The DTX-9909K The DT The DT is in Music Mode
whenever there are no microphone cables connected to
either of the microphone inputs.
Below is a list of the available speakers settings and their
available options:
Accessing the Speaker Settings Menu
To access the speaker settings, press the Main Menu but-
ton on the front panel or the Menu button on the remote
control.
Using the Speaker Settings Menu
Front Panel
1. Press the Main Menu button on the front panel to cycle
through all of the speaker settings.
2. Use the Input/Adjust control to change the parameters
for each setting
Remote Control
1. Press the Menu button on the remote control to access
the Speaker Settings menu
2. Use the and buttons to cycle through all of the
speaker settings
3. Use the and buttons to change the parameters for
each setting
Available Speaker Settings:
Below is a list of the speaker settings available in the
Speaker Settings Menu
• M Speaker (Main Speakers)
Use the Input/Adjust knob on the front panel or the and
buttons on the remote control to select the parameter.
Choices: Large, Small
Large - If your main speakers have a high ability for bass
reproduction. In this position, full-range signals present in
the main channels are output from the main speakers.
Small - If your main speakers do not have a high ability
for bass reproduction. However, if your system does not
include a subwoofer, do not select this position. In this
position, low bass signals are output from the subwoofer
output (100Hz).
• C Speaker (Center Speaker)
Use the Input/Adjust knob on the front panel or the and
buttons on the remote control to select the parameter.
Choices: Large, Small, and None
Large - If you have a large surround center speaker. The
entire range of the surround center signal is directed to
the surround center speaker.
Small - If your center speaker does not have a high ability
for bass reproduction. In this position, low bass signal
(100 Hz) in the center channel is output from the sub-
woofer speaker, or from the left and right main speaker if
the subwoofer setting is set to the “N (none)” position.
None - Select this position if your system does not include
the center speaker. The center-channel will be output
from the left and right speakers instead.
Speaker Settings Menu