VeriFone NURIT 8400 - Manual (Page 20)

S ETUP
Connecting the Battery Pack
20 NURIT 8400 I NSTALLATION G UIDE
Connecting the
Battery Pack
Some models of the NURIT 8400 come with a battery pack. If your model comes
with a battery pack, read this section to know how to install and remove the pack.
Depending on your model of the NURIT 8400 terminal, the battery pack
compartment may be shared with the SAM and SD cards. To gain access to the
battery pack/card compartment, you must first remove the battery pack/card
compartment cover. For information on removing and replacing the battery pack/
card compartment cover, see
Opening and Closing Compartment Covers .
Connecting and
Removing the
Battery Pack
Some models of the NURIT 8400 allow you to operate the terminal without an
external power supply, by using a battery pack.
To connect the
battery pack
1 Disconnect the DC power supply cord from the terminal.
2 Remove the battery compartment cover. See Figure 4 .
3 Turn the battery so that the connecting wires are at the top right hand corner.
4 Insert the battery pack pin connector into the 2-pin port in the battery pack
compartment. The straight side should be facing outwards, while the rounded
edges should be facing inwards, towards the compartment.
5 Insert the battery pack into the battery compartment.
6 Push the connecting wires gently into the cable guide.
Figure 11 Connecting the Battery Pack
7 Close the battery compartment cover. See Figure 5 .
8 Connect the DC power supply to the terminal (see Figure 17 ) or power on the
terminal (see Powering On and Off the Terminal With a Battery Pack ).
WARNING
Only use battery packs provided by VeriFone. For information about purchasing
additional or replacement batteries, see Accessories and Documentation .
CAUTION
Make sure to disconnect the DC power supply cord from the terminal before
connecting or removing the battery pack.