Uniden TRAX436 - Manual (Page 55)

Page 55
How Do I Use It?
• To select the settlement from the list of recently used ones,
tap the button.
• To enter a new settlement:
1. Tap the button with the name of the settlement, or if you
have changed the country/state, tap .
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
• After entering a couple of characters, the names that
match the string appear in a list.
• Tap to open the list of results before it
appears automatically.
4. Pick the settlement from the list.
4. Tap the button.
5. The map appears with the selected point in the middle. Tap
(Simple mode) or
(Advanced mode) from the Cursor menu. The route is then
automatically calculated, and you can start navigating.
Entering an address with a postal code
The current Sensis R15 map does not support Post Codes as
described in this section.
All of the above address searching possibilities can be performed with
entering the postal code instead of the settlement name. Find below an
example with a full address:
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons: (Simple mode), or
NOTE