Uniden TRAX436 - Manual (Page 46)

Page 46
How Do I Use It?
Selecting the destination of a route
TRAX436 offers you several ways of choosing your destination and via
points (intermediate destinations):
• Use the selected location on the map (the Cursor) (page 46).
• Enter a full address or a part of an address, for example a street
name without a house number or the names of two intersecting
streets (page 47).
• Enter an address with postal code (page 55). This way you do
not need to select the name of the settlement and the search for
street names might be faster as well.
• Use a coordinate (page 60)
• Use a saved location:
•
a Favourite (page 57)
• a POI (page 58)
• the History of previously set destinations and waypoints
(page 60)
If you are going to use a route later, save it before you start
navigating. Tap the following buttons:
, , .
Selecting the Cursor as the destination
1. Locate your destination on the map: move and scale the map
as needed (page 14).
2. Tap the location that you want to select as your destination. The
Cursor (
) appears.
3. Tap to open the Cursor menu.
4. The map appears with the selected point in the middle. Tap
(Simple mode) or
TIP