Toshiba 51H93 User Manual

Page 8

1. Carefully read the important safety, installation,

care, and service information on pages 2–4.
Keep this manual for future reference.

2. Do not plug in any power cords until AFTER you have

connected all cables and devices to your TV.

3. If you need to split your TV into two sections during

moving or installation, read the “Important Safety Precautions
for Split Cabinet Feature” on page 5.

4. Consider the following when selecting a location

for your TV:

• Place the TV on the floor only.

• Place the TV in a location where light does not reflect on

the screen.

• Place the TV far enough from walls and other objects to

allow proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY BECAUSE IT IS A RESULT OF MISUSE.

• Read “Installation” on pages 3–4.

5. Remove the demo pin from the G-LINK jack on the

back of the TV (see illustration below).

8. Connect one of the the enclosed IR blaster cables

from your VCR and/or Cable box to the G-LINK jack so you
can use the TV Guide On Screen™ one-touch recording
feature. See page 25.

9. AFTER connecting all cables and devices, plug in

the power cords for your TV and other devices.

10. Install the batteries in the remote control (page 27).

11. See “Learning about the remote control” for an

overview of the buttons on the remote control
(page 26).

12. Program the remote control to operate your other

device(s) (pages 27–33).

13. Turn on the TV and other device(s).

14. Follow the on-screen Quick Connect Guide for

assistance in configuring the TV’s settings and setting up
the TV Guide On Screen

™

program guide. (The Quick

Connect Guide starts automatically the first time you turn on
the TV.) See page 36 for details.

15. Program channels into the TV’s channel memory

(page 42), if you did not already do so during the Quick
Connect Guide setup.

16. See “Menu layout and navigation” (page 34) for a

quick overview of the TV’s menu structure and
navigation (page 35).

17. See Chapter 7 for details on using the TV Guide On

Screen™ program guide (if available in your area)
(page 53).

18. Set up the TheaterNet™ on-screen device control

feature (if applicable to your particular home theater system
components) (page 45).

19. See page 80 for details on using the

SmartMedia™/SD JPEG picture viewer.

20. See Chapter 8 for details on using the TV’s features.

21. For technical specifications, see page 93.

22. For help, refer to the Troubleshooting Guide on

pages 88–92.

23. For warranty information, see page 94-95.

24. Enjoy your new TV!

Overview of steps for installing, setting up, and using your new TV

Follow these steps to set up your TV and begin using its many exciting features.

Chapter 1: Introduction

ANT( 75 )

REC OUT

ANT-1

ANT-2

AUDIO

VIDEO

DVI/HDCP IN

G-LINK

TV back panel

DEMO PIN

This Demo Pin

automatically activates the

TV Guide On Screen demo.

RETAILERS:

Do not remove this Demo Pin.

Removal will disable

the automatic demo.

CONSUMERS:

Remove this Demo Pin

and insert the IR blaster cable

here before using your

TV.

6. BEFORE connecting cables or devices to the TV,

learn the functions of the TV’s connections and controls
(page 10).

7. Connect your other electronic device(s) to the TV

(pages 12–25).

➚