Installing the remote control batteries – Toshiba 51H93 User Manual
Page 27
Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.
27
Chapter 3: Using the remote control
MODE
Device mode control after programming
TV
Toshiba TV
CABLE/SAT Multi-brand Cable, Satellite
VCR
Multi-brand VCR, DVD, LD, Cassette
DVD
Multi-brand DVD, VCR, LD, Cassette
AUDIO 1
Multi-brand Audio: Amp., Tuner, Misc.Audio, CD/MD
AUDIO 2
Multi-brand Audio: CD/MD, Amp., Tuner, Misc. Audio
Note:
Although your new TV’s remote control includes
codes for many devices, it may not include
codes for some or all of the features on certain
devices you wish to control. If you are unable to
program the TV’s remote control to operate
your device or some of the features on that
device, use the device’s remote control or the
controls on the device.
MODE
+
PA
G
E
–
ACTION
ENTER
MENU
THEATER
NET
FAV
–
100
+10
Your TV remote control has one dedicated TV mode and five programmable
multi-brand modes: CABLE/SAT, VCR, DVD, AUDIO 1, and AUDIO 2.
The default device modes and programmable device modes are listed below.
Note: The TV remote control is preprogrammed to operate most Toshiba devices.
If you own a non-Toshiba device or a Toshiba device that the remote control is not
preprogrammed to operate, you will need to program the remote control. See
“Programming the remote control to operate your other devices” on page __.
MODE
Default device mode control (before programming)
TV
Toshiba TV
CABLE/SAT Toshiba Satellite receiver
VCR
Toshiba VCR
DVD
Toshiba DVD
AUDIO 1
Pioneer Audio receiver
AUDIO 2
Pioneer LD
Using the remote control MODE button to control other devices
Caution:
• Dispose of batteries in a designated disposal
area.Do not throw batteries into a fire.
• Do not mix battery types or combine used
batteries with new ones.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace both batteries with new
ones.
• If the batteries are dead or if you will not use
the remote control for a long time, remove
the batteries to prevent battery acid from
leaking into the battery compartment.
To install the remote control batteries:
1. Slide the battery cover off the back of the remote control.
2. Install two “AA” size alkaline batteries. Match the + and – symbols on the
batteries to the symbols on the battery compartment.
3. Slide the battery cover on to the remote control until the lock snaps.
Installing the remote control batteries