Completing the quick connect guide assisted setup, Important final setup steps, Configuring the ant 1 input source – Toshiba 51H93 User Manual
Page 40: Selecting the picture mode, Adjusting the color convergence, Completing the quick connect guide setup
Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.
40
Chapter 5: Quick Connect Guide & TV Guide On Screen setup
The following screen appears. Highlight NEXT and press
ENTER.
Quick Connect Guide
Please connect as follows:
For advanced connection, please see owner’s
manual.
From CABLE or ANTENNA -----> ANT 1 TV
Next
Back
Note: The text on this screen may vary, depending on your
specific device connection.
Configuring the ANT 1 input source
Highlight your ANT 1 input source—antenna or Cable—
and press ENTER.
Quick Connect Guide
Please select your source.
Cable
Antenna
Programming channels into the channel memory
Press ENTER to start automatically programming all active
channels (for the current input source) into the TV’s
channel memory. This will enable you to use the
CH
y z buttons on the remote control or TV front panel
to change channels.
• For details on channel programming, see page 44..
Quick Connect Guide
Your TOSHIBA TV can memorize all available TV
channels automatically.
Press ENTER to start
Next
Back
ANT 1
Cable
Scanning channels, please wait...
Abort
0%
i
Selecting the picture mode
Highlight the picture mode you prefer, and then press
ENTER.
• For details on the picture modes, see page 72.
Quick Connect Guide
Please select your favorite Picture Mode.
Sports: Bright & dynamic
STANDARD: Normal TV picture
MOVIE: Movie-like
Movie
Sports
Standard
Adjusting the color convergence
Press the TOUCH FOCUS button on the TV front panel
to start automatic color convergence
• For details on adjusting the color convergence, see page 50.
Quick Connect Guide
Please push the TOUCH FOCUS button on the front
panel. The TV will automatically adjust the
convergence of the three picture tubes. It is best to
repeat this process whenever the picture appears
unclear.
Next
Back
Completing the Quick Connect Guide setup
Highlight END and press ENTER to exit the Quick
Connect Guide.
Quick Connect Guide
Basic setup has been completed.
Thank you.
End
Back
Completing the Quick Connect Guide assisted setup
Important final setup steps
When you have completed the Quick Connect Guide setup process, follow these
steps so your TV can receive TV Guide On Screen program data as quickly as
possible (otherwise, it may take up to 24 hours for the TV to receive program data).
1. Turn OFF your TV overnight.
2. If you have a Cable box connected, leave it ON.
3. If you have a VCR connected, turn it OFF.
4. If you have more than one Cable system in your area, you may be
prompted to select which Cable system’s program data to download.
If so prompted, follow the on-screen instructions.