Adjusting the audio, Adjusting the audio quality, Using the sub-bass system (sbs) – Toshiba 51H93 User Manual
Page 77: Continued)
Copyright © 2003 TOSHIBA CORPORATION. All rights reserved.
77
Chapter 8: Using the TV’s features
Adjusting the audio quality
You can adjust the audio quality by adjusting the bass, treble,
and balance.
To adjust the audio quality:
1. Press MENU and open the AUDIO menu.
2. Highlight AUDIO SETTINGS and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
3. Press
z to highlight the item you want to adjust (BASS,
TREBLE, or BALANCE).
Audio Settings
Bass
Treble
Balance
SBS
SBS Level
StableSound
Save
Done
Reset
On
On
76
50
0
50
4. Press
x or • to adjust the level.
•
x makes the bass or treble weaker or increases the balance
in the left channel (depending on the item selected).
•
• makes the bass or treble stronger or increases the balance
in the right channel (depending on the item selected).
5. To temporarily save the new settings, highlight DONE and
press ENTER. To permanently save the new settings,
highlight SAVE and press ENTER.
To reset the audio quality to the factory settings:
Highlight RESET in step 5 above, and press ENTER.
The bass and treble are reset to 50 and the balance is reset
to 0.
Audio Settings
Bass
Treble
Balance
SBS
SBS Level
StableSound
Save
Done
Reset
On
Off
50
50
0
70
Adjusting the audio
(continued)
Using the sub-bass system (SBS)
The sub-bass system enhances bass performance, even when the
volume is low.
To turn on the SBS and adjust the SBS level:
1. Press MENU and open the AUDIO menu.
2. Highlight AUDIO SETTINGS and press ENTER.
Audio
Audio Settings
Advanced Audio Settings
Audio Setup
3. Press
z to highlight SBS, and then press • to select ON.
4. Press
z to highlight SBS LEVEL, and then press • or x to
adjust the level.
Audio Settings
Bass
Treble
Balance
SBS
SBS Level
StableSound
Save
Done
Reset
On
On
50
50
0
65
5. To temporarily save the new settings, highlight DONE and
press ENTER. To permanently save the new settings,
highlight SAVE and press ENTER.
To turn off the SBS feature:
Select OFF in step 3 above.
Note:
When SBS is set to OFF, if the SBS level is adjusted, the SBS is
automatically set to ON.