Tally Genicom Matrix Printer User Manual
Tally Genicom Printers
Table of contents
Document Outline
- 7265 Programmer’s Manual
- Table of Contents
- Chapter 1. Introduction
- Chapter 2. ANSI
- Control Code Summary
- Control Code Comparison, 7 Bit/8 Bit
- 8-bit Control Codes
- Escape Sequence Summary
- Printer Handshaking
- Printer Control
- Graphics Rendition (Fonts and Modes)
- NATIONAL CHARACTER SET
- Line/Character Spacing
- Forms Setup
- Superscript/Subscript
- Vertical Movement
- Vertical Movement
- Margins
- Horizontal Movement
- Tabs
- Dot Graphics
- Graphics Control Functions
- Chapter 3. ANSI Bar Codes
- Before You Begin - Set the Form Length
- Setting Bar Code Parameters
- General Rules for Assigning Parameters
- Bar Code Command Sequences
- p1 - Bar Code Style
- p2 – Height
- p3 - Human Readable Enable
- Element Widths
- p5 - Wide Bar Width
- p6 - Narrow Space Width
- p7 - Wide Space Width
- p8 - Intercharacter Gap
- Other Parameters
- p9 – Rotation
- p10 - Horizontal Resolution
- p11 - Check Character Enable
- p12 - Human Readable Font
- p13 - Height in 1/24-inch Increments
- Delimiters
- Calculating Characters per Inch
- Bar Code Style Characteristics
- Interleaved 2 of 5 (Style 0)
- Bidirectional/Industrial 2 of 5 (Styles 1 and 3)
- Matrix 2 of 5 (Style 2)
- Code 3 of 9 (Style 4)
- EAN-8 (Style 5)
- EAN-13 (Style 6)
- Code 11 (Style 7)
- Code BCD (Style 8)
- Codabar A/t, B/n, C/*, D/e (9, 10, 11, 12)
- UPC-A (Style 13)
- UPC-E (Style 14)
- Code 93 (Style 15)
- Code 128 (Style 16)
- MSI (Style 19)
- UPC/EAN 2 Supplement (Styles 20 and 22)
- UPC/EAN 5 Supplement (Styles 21 and 23)
- POSTNET (Style 50)
- Calculating the Checksum for Code 3 of 9
- Code 93 Checksums for Full ASCII
- Checksum calculation for the symbol Cat
- Code 93 Full ASCII Table
- Chapter 4. ANSI Oversized Font
- Control Function Summary
- Oversized Control Functions
- Oversized Versus Expanded
- Setting the Expansion
- Device Timeout with Very Large Characters
- What is a Character Cell?
- Oversized Character Dimensions – 0 o and 180 o
- Oversized Character Dimensions - 90 o and 270 o
- Vertical Position-Relative in Oversized
- Implementing the Line Feed Function - 0 o and 180 o
- Line Spacing and Intercharacter Spacing – 90 o and 270 o
- Option 1 Disabled
- Option 1 Enabled
- Finding the Baseline of an Oversized Character
- Appendix A. Commands and Exceptions
- Epson Emulation Reference
- Tally ANSI Reference