Tally Genicom Matrix Printer - Manual (Page 263)

Character Styling
Superscript ON CSI 0 z
Subscript ON CSI 1 z
Microscript ON CSI 10 z
Super-/Sub-/Microscript OFF
CSI 2 z
Data Structure ASCII CSI n "z" [A] character styling
hex. 9B n 7A
dec. 155 n 122
Description For n the following parameters are availble:
n hex. dec. character styling
0 30 48 superscript ON ➊
1 31 49 subscript ON ➊
2 32 50 super-/sub-/microscript OFF
➋
10 31 30 49 48 microscript ON ➊
➊ These sequences switch the printer to superscript, subscript or microscript mode. The
subsequent characters are printed with about
1 ⁄
2 of their normal height. If superscript
or subscript characters are underlined, the underline character is printed at its normal
position.
➋ This sequence resets the printer to normal mode.
The base line for microprint is the same as for normal print.
The sequence CSI 2 z also resets double height.
(For this see also the following page 29, Double Height OFF)
Character Styling 27