Tally Genicom Matrix Printer - Manual (Page 41)

7265 Programmer’s Manual 37
Copyright © 2004 TallyGenicom Chapter 3 ANSI Bar Codes
Bar Code Command Sequences
Command Description
ESC [3t ENABLE BAR CODES
Enables Bar Codes with the characteristics set by ESC [(p1);(p2)…}.
ESC [3t selects Bar Code mode and
activates Bar Code printing.
Dec 27 91 51 116
Hex 1B 5B 33 74
ESC [0t CANCEL OVERSIZED/EXPANDED/BAR CODE MODES
Dec 27 91 48 116
Hex 1B 5B 30 74
SO SHIFT OUT
Turns off bar code printing, then enters bar code mode again.
Dec 14 Hex 0E
SI SHIFT IN
SI
turns bar code printing off.
Dec 15 Hex 0F