Toshiba 17WLT46B - Manual (Page 59)

58
Search for and store the test
signal of the video recorder
• Unplug the aerial cable from the aerial
socket “ANT” of your video recorder.
• Switch on your TV and put the video re-
corder on the test signal. (See the hand-
book for your video recorder.)
• Search for the test signal of your video re-
corder in the same way as you searched
for and stored the TV signals. See Install,
Search and Store TV channels. Store the
test signal under programme number 0.
– Replace the aerial cable in the aerial socket
“ANT” of your video recorder once you
have stored the test signal.
Camera and Camcorder
To connect to (AV-3) input
Connect your camera or camcorder at the
back side of your TV.
• Connect your equipment to the TV via
VIDEO (yellow), AUDIO R (red) and AU-
DIO L (white) inputs. You should connect
the jacks to the input in the same colour.
Connect the decoder to the
video recorder
Some video recorders have a special euro-
connector for decoder.
• Connect a eurocable to the euroconnector
of your decoder and to the special
euroconnector of your video recorder. See
also the handbook of your video recorder.
• To connect your video recorder to the TV,
see TV and Video Recorder section.
If you want to connect more equipment to
your TV, consult your dealer.
Connecting Headphones
Use the stereo headphone socket on the
back side of your TV, to connect head-
phones.
Connecting the PC
Connect PC monitor with 15-pin PC cable to
the 15-pin connector on the rear of the com-
puter. For detail installation procedure see
Installation in PC mode.
To connect to S-Video input
Connect your camera or camcorder at the
back side of your TV.
• Connect your equipment to the TV via S-
Video input at the back side by using S-
Video cables.
50052932-1552UK (TOSHIBA UK)17 INCH TFT-IDTV-WO WM-dilek p65 11 05 2004 15:30 58