Toshiba B-492L - Manual (Page 67)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.6 Test Print
A4-17
A4.6 Test Print (Cont.)
Issue Mode Selection
Select the issue mode for the test print by selecting between “[S]
NORMAL” (Batch mode) and “[H] PEEL OFF” (Strip mode).
After selecting the Issue Mode, press the [PAUSE] key to go to Label
Length Setting.
Label Length Setting
Select the label length for the test print in a range from 5 mm to 999 mm.
[FEED]
key: Pressing the [FEED] key once causes a –1 mm
change, down to 5 mm.
[RESTART] key: Pressing the [RESTART] key once causes a +1 mm
change, up to 999 mm.
After selecting the label length, press the [PAUSE] key to go to Paper
Feed Selection.
Paper Feed Selection
Select whether or not a paper feed is performed.
After selecting the paper feed, press the [PAUSE] key. If "PAPER
FEED" was selected the printer will feed the media. The display returns
to the “<4>TEST PRINT”.
7<3(>6@1250$/
7<3(>+@3((/ 2))
7<3(>6@1250$/
[RESTART]
[FEED]
Batch mode
Strip mode
[RESTART]
[FEED]
/$%(/ /(1 PP
/$%(/ /(1 PP
/$%(/ /(1 PP
3$3(5 )(('
3$3(5 12 )(('
3$3(5 )(('
[RESTART]
[FEED]
Paper feed is
available.
Paper feed is not
available
.
NOTE:
Press and hold the [RESTART]
or [FEED] key to advance the
values quickly and continuously.
To stop, release the key.
NOTE:
When “PAPER FEED” is
selected, the printer feeds the
media to the correct print start
position for the selected
conditions.
When “PAPER NO FEED” is
selected, the printer makes no
pre-feed to set the print start
position. If the print start
position adjustment is
unnecessary, Select "PAPER
NO FEED" and save media.