Toshiba B-492L - Manual (Page 63)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.5 Printer Parameter Fine Adjustment
A4-13
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
Threshold Manual Fine Adjustment (Black Mark/Feed Gap
Sensor)
With this parameter you can fine adjust the Threshold of the Black Mark
and Feed Gap Sensors. With “<3>ADJUST SET” displayed, press the
[PAUSE] key 9 times to enter the Threshold Manual Fine Adjustment
(Black Mark Sensor) menu.
To change the screen to the Threshold Manual Fine Adjustment (Feed
Gap Sensor), press the
[PAUSE] key again.
[FEED] key: Pressing the [FEED] key once causes a –0.1V change,
down to 0.0V.
[RESTART] key: Pressing the [RESTART] key once causes a +0.1V
change, up to +4.0V.
After completing the fine adjustment, press the
[PAUSE] key.
Strip Motor Driving Speed Fine Adjustment
With this parameter you can fine adjust the speed of the backing paper
peel motor (stepping motor). With “<3>ADJUST SET” displayed, press
the
[PAUSE] key 10 times to enter the Strip Motor Driving Speed Fine
Adjustment menu.
After completing the fine adjustment, press the
[PAUSE] key.
NOTE:
This is useful to fine adjust the
threshold if problems with
media issue persist after the
sensor threshold setting is
performed. (See Section 6.4
Threshold Setting) If the
problem cannot be resolved,
please contact your nearest
TOSHIBA TEC service
representative.
7+5(6+2/'7!9
[RESTART]
[FEED]
7+5(6+2/'5!9
7+5(6+2/'5!9
7+5(6+2/'5!9
7+5(6+2/'5!9
7+5(6+2/'5!9
7+5(6+2/'7!9
7+5(6+2/'7!9
7+5(6+2/'7!9
7+5(6+2/'7!9
7+5(6+2/'7!9
Black Mark Sensor Feed Gap Sensor
7+5(6+2/'5!9 Black Mark Sensor
Feed Gap Sensor
3(/ 2)) 63(('
[RESTART]
[FEED]
3(/ 2)) 63(('
3(/ 2)) 63(('
3(/ 2)) 63(('
3(/ 2)) 63(('
3(/ 2)) 63(('
NOTE:
The fine adjustment value
equals to the sum of the fine
adjustment values set by the PC
command and this parameter.
The maximum strip motor
driving speed fine adjustment
value is +4 step. When the
addition of the values reaches
the maximum, the value
remains unchanged even if
subsequent fine adjustments are
made.