Toshiba B-492L - Manual (Page 17)

2. PRINTER SETUP EO1-33032
2.7 Loading the Media
2- 6
2.7 Loading the Media
This section describes in detail how to load the media.
1. Open the top cover and turn the head lever and pinch roller lever to
position
d, then open the ribbon shaft holder plate.
2. Insert the media into the printer from the side as shown in the figure
below. Ensure that the media is positioned in the black mark/feed gap
sensor.
WARNING!
1. Do not touch any moving
parts. To reduce the risk
of fingers, jewellery,
clothing, etc. being
drawn into the moving
parts, be sure to load the
media once the printer
has stopped moving
completely.
2. To avoid injury, be
careful not to trap your
fingers while opening or
closing the cover.
3. Be sure to open the top
cover fully, otherwise the
top cover may close,
causing injury.
NOTES:
1. When the head lever is
turned to position
@, the
print head is raised.
2. When the pinch roller lever
is turned to position
@, the
pinch roller is raised.
3. To enable printing the head
lever and the pinch roller
lever must be set to position
?. This ensures that the
print head and the pinch
roller are closed.
HEAD
2 1
c
d
Top Cover
Head Lever
Ribbon Shaft
Holder Plate
Pinch Roller
Lever
Media