Toshiba B-492L - Manual (Page 61)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.5 Printer Parameter Fine Adjustment
A4-11
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
Print Tone Fine Adjustment (Thermal Transfer/Thermal Direct
Print)
With this parameter you can fine adjust the density of the Print Tone.
When “<3>ADJUST SET” appears, press the
[PAUSE] key 5 times to
enter the Print Tone Fine Adjustment (Thermal transfer print) menu.
To change the screen to the Print Tone Fine Adjustment (Direct Thermal
print), press the
[PAUSE] key again.
[FEED] key: Pressing the [FEED] key once causes a –1 tone
change, down to –10 tones.
[RESTART] key: Pressing the [RESTART] key once causes a +1 tone
change, up to +10 tones.
After completing the fine adjustment, press the
[PAUSE] key.
NOTES:
1. The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter. The maximum
print tone fine adjustment
value is
±
10.
The following table shows
the maximum fine
adjustment value for each
print speed. Even if the set
value exceeds the maximum
value, it will be
automatically adjusted to the
following value.
2. This is useful when print
density change is required
e.g.) If the ribbon is changed
to different type.
721( $'-'!
[RESTART]
[FEED]
721( $'-7!
721( $'-7!
721( $'-7!
721( $'-7!
721( $'-7!
721( $'-7!
721( $'-'!
721( $'-'!
721( $'-'!
721( $'-'!
721( $'-'!
Darker
Lighter
Standard
Thermal Transfer Print Thermal Direct Print
Thermal Transfer
Thermal Direct
Print Thermal Thermal
speed Direct transfer
4”/sec. +2 step
5”/sec. +5 step +5 step
8”/sec. +2 step +2 step
10”/sec. +2 step