Toshiba B-492L - Manual (Page 19)

2. PRINTER SETUP EO1-33032
2.7 Loading the Media
2- 8
2.7 Loading the Media
(Cont.)
7. After loading the media, it may be necessary to set the media sensors
used to detect the print start position of the labels. Set the black
mark/feed gap sensor to the correct position by turning the adjusting
knob.
Setting the feed gap sensor position
Turn the adjusting knob to move the feed gap sensor to the centre of the
labels to detect the gap between labels. If the labels are round, set the
sensor to detect the area of the shortest distance between the labels.
( indicates the position of the feed gap sensor).
Setting the black mark sensor position
(1) Pull about 500 mm of media out of the front of the printer, turn the
media back on itself and feed it under the print head past the sensor
so that the black mark can be seen from above.
(2) Turn the adjusting knob to move the black mark sensor so that it is
in line with the center of the black mark on the media. ( indicates
the position of the black mark sensor.)
NOTES:
1. Turning the adjusting knob
to the right will move the
sensor towards the center
of the media while turning
it to the left will move it
away from the center of the
media.
2. Be sure to set the black
mark sensor to detect the
center of the black mark,
otherwise a paper jam or
no paper error may occur.
Label
Feed Gap Sensor
Label
Adjusting Knob
Gap between Labels
Black Mark Sensor Black Mark
Adjusting Knob