Overview, A4.2 overview – Toshiba B-492L User Manual

Page 52

APPENDIX 4 SYSTEM MODE

EO1-33032

A4.2 Overview

A4- 2

A4.2 Overview

The System Mode consists of nine main menu items: Reset, Self-
Diagnostic Test, Parameter Setting, Printer Parameter Fine Adjustment,
Test Print, Sensor Adjustment, RAM Clear, IP Address Setting, and
Dump mode.

Press the

[PAUSE]

key so that the printer enters the Pause condition.

Then, press and hold the

[RESTART]

key until “<0>RESET” appears on

the display.

NOTE:

1. To navigate the System Mode

menus the

[RESTART]

and

[FEED]

key can be used.

2. Pressing the

[PAUSE]

key

will enter the sub menus of
each System Mode menu.
Flowcharts of each sub menu
are provided on the following
pages.

[FEED]

This leads to the Self-Diagnostic
Test menu.

This leads to the Printer Parameter
Fine Adjustment menu.

This leads to the Test Print menu.

This will Reset the printer.

[RESTART]

!',$* 9[[

!$'-867 6(7

!7(67 35,17

IMPORTANT!

The

following menus are for

Service Personnel only:

<2>PARAMETER SET
<5>SENSOR ADJ.
<6>RAM CLEAR
<7>IP ADDRESS

Please do not change the
settings for these items, as
doing so may cause the
printer to malfunction.
If you should accidentally
enter these System Modes, to
exit just turn the power off. If
you should change any of the
settings by accident and the
printer malfunctions, please
contact your nearest
TOSHIBA TEC service
representative.

!5(6(7

!3$5$0(7(5 6(7

!6(1625 $'-

!5$0 &/($5

!,3 $''5(66

!'803 02'(

[FEED]

[RESTART]

[FEED]

This leads to the Parameter Setting
menu.

This leads to the Sensor Adjustment
menu.

This leads to the RAM Clear menu.

This leads to the IP Address Setting
menu.

This leads to the DUMP mode menu.

This manual is related to the following products:

R-TH10