Toshiba B-492L - Manual (Page 46)

APPENDIX 1 SPECIFICATIONS EO1-33032
A1.3 Media
A1- 4
A1.3.3 Detection Area of the Reflective Sensor
The reflective sensor is movable from the center to the left edge of media.
The reflection factor of the black mark must be 10% or lower with a waveform length of 950 nm.
The reflective sensor should be aligned with the center of the black mark.
A1.3.4 Effective Print Area
The figure below illustrates the relation between the head effective print width and media width.
The figure below shows the effective print area on the media.
Sensor should be positioned at
the center of the black mark.
Center of media
Min. 12 mm
Media feed direction
2 to 20 mm
Sensor is movable
within this range.
NOTES:
1. Avoid printing in the area 1.5-mm wide from the media edges (shaded area in the above figure).
2. The center of media is positioned at the center of the print heads.
3. Print quality is not guaranteed within 3 mm from the print head stop position (including 1-mm slowup).
4. Average print (black) rate should be 15% or less. For bar code print area, the print rate should be 30%
or less.
5. Line weight should be 3 to 12 dots.
Detecting the black
marks on the back.
Start line
Area to be detected.
Area to be detected.
Media feed direction
1.5 mm from the
left edge of
media
Media width
(backing paper width is not included.)
1.5 mm from the right
edge of media
1 mm
1 mm
Guaranteed print area
Print Head Element Out of print range Out of print range
2.7
mm
2.7
mm
104.0 mm ± 0.2 mm
(Head Effective Print Range)
112.0 mm (Maximum paper width)