Toshiba TDP-MT500 - Manual (Page 33)

33
How to see the internal states from indicators
There are three indicators that show the status of the projector. Check the followings, and if there is any
phenomenon, stop use of the projector and be sure to unplug the power plug. Then, contact your dealer.
On in red
On in red
On in green
On in
orange
POWER LAMP TEMP STATE REMARK
On in
orange
Blinking
in red
Off
Off
Off
On in red
Replace the light-source lamp to a new
one. Purchase a light-source lamp from
the delivery agent of the projector.
Blinking
in red Blinking
in red
• Press the POWER button after the
POWER indicator has stopped a blinking.
• If this operation is repeated several
times and the light-source lamp still does
not come on, replace the lamp with a
new one. Ask your dealer.
• Ask your dealer.
The interior of the projector is very hot.
• The intake vent and/or exhaust vent is blocked
with something.
• The projector is used at a very hot place such as
outlet of heating air.
The protection circuit is working, or
The lamp is not normal.
(When power is turned off normally, this indication
appears, and this is not a failure.)
Solution
• Make sure the vent is not blocked.
• Relocate the projector.
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "ON".)
Indicating replacement of the lamp (Used about 1000
hours* in total; Power is "OFF".)
Indicating replacement of the lamp (Used about 1500
hours* in total)
The cooling system error.
or
On in orange
On in green
Blinking in green
Blinking in orange
POWER LAMP TEMP STATE REMARK
Power "ON" (usually).
Lamp standby state. Power can not be turned "OFF".
Lamp is being cleaned. Power can not be turned "ON".
Standby state.
Off Off
If the projector is not normal:
When the projector is normal:
LAMP indicator
TEMP(temperature) indicator POWER indicator
INDICATORS
Kensington Lock
This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security
System. Refer to the information that came with the Kensington System for instructions on how to use it to
secure the projector. Please contact to Kensington Technology Group as shown below.
Kensington Technology Group
2855 Campus Drive
San Mateo, CA 94403, U.S.A.
Phone :+1- (650)572-2700 Fax :+1- (650)572-9675