Viewing computer images – Toshiba TDP-MT500 User Manual
Page 24

24
When stopping projection:
8 Press the POWER ( ) button.
•
A confirmation message appears on the screen.
•
To cancel this state, wait for a while, or press the EXIT
button or MENU button on the remote control, or press
the MENU/EXIT button of the projector.
9 Press the POWER ( ) button again.
•
The light-source lamp goes off and the projector goes
to standby. The POWER indicator blinks in orange.
10 Wait about 2 minutes until the POWER indicator
comes on in orange.
•
Wait about 2 minutes in the standby state, because
during this time the intake/exhaust fan is cooling the
light-source lamp.
•
The intake/exhaust fan continues to turn for about one
minute after the POWER indicator has come on in
orange.
•
Do not turn off the main power switch while the
POWER indicator is blinking. If the main power switch
is turned off immediately after use, the projector may
malfunction.
•
The fan makes a loud sound while cooling down, but
this is not a malfunction.
11 Turn “OFF” the main power switch (I
➔
O).
•
When the projector is not used for a long time, unplug
the power plug from the power outlet for safety.
•
Attach the lens cap to prevent dust from being gath-
ered from outside.
VIEWING COMPUTER IMAGES
Main power switch
POWER button
POWER button /
POWER indicator
POWER ON/STANDBY
C1
C2
DVI
D
DVI
A
S
V
COMP1
COMP2
DVI-D
DVI-A
VIDEO
S-VIDEO
16:9
16:9
4:3
4:3
ZOOM
ZM
REAL
REAL
DYN
DYNAMIC
1
2
3
ENTER
EXIT
MENU
CONTRAST BRIGHT
COLOR
TINT
COLOR
TEMP
GAMMA SHARPNESS
LIGHT
LIGHT
SH
GAM
TEM
TIN
COL
BRI
CNT
SOURCE
ASPECT
Notebook type computer
When the projector is connected to a notebook type computer, the picture images from the computer may
not be projected on screen. For this situation, set up the computer so that it may output picture signals.
How you do this to set up the computer depends on the type of computer you have. Refer to the instruction manual
of the computer.
Example of set up for the external output:
Press “Fn” key and any of “F1” to “F12” key (Depends on the type of the computer).