Transcend Information III - Manual (Page 58)

5-10 C HAPTER 5: P ERFORMING T ROUBLESHOOTING AND D IAGNOSTIC T ESTS
10 If you experience problems that occur only when using
the AutoLink program, display or print the AUTOLINK.LOG
file. The AUTOLINK.LOG file contains a log of all the events
that occurred during the AutoLink installation and
configuration process.
a To display the file, type:
type autolink.log | more
b To print the file, type:
print autolink.log
Changing the Test Setup
To change the test parameters, follow these steps:
1 Choose Test Setup from the Test menu in the main
window of the Configuration and Diagnostic Program, or
choose the
Test Setup button in the Run Tests dialog box.
2 Press [Tab] to highlight any of the fields within the Test
Setup dialog box.
3 To change a setting in any field, follow these steps:
a In the Group Select box, use the arrow keys to select a
test group.
For more information on the Group 2 or Group 3 tests, refer to
the appropriate sections earlier in this chapter.
b In the Group X Tests box, use the arrow keys to highlight
a test. Press the [Space Bar] to enable or disable an
individual test.
c In the Repetitions box, specify the number of times you
want to run the tests, or use the arrow keys to select the
Continuous option.
d In the Errors box, press the [Space Bar] to select or
deselect the Halt on Error parameter.
4 When you are satisfied with the new test setup, select the
OK button and press [Enter].