Transcend Information III - Manual (Page 55)

Starting the Diagnostic Program 5-7
3 Start the diagnostic program on the echo server.
The diagnostic program that you use depends on the adapter
that is installed in the echo server. After the system prompt of
the drive containing the Configuration and Diagnostic
Program, enter the name of the appropriate program (for
example, 3C523) from Table 5-1.
The diagnostic programs listed above come on the EtherDisk
diskette that accompanied the adapter.
4 Select Echo Server Setup on the main menu.
The program notifies you that your computer is now set up as
an echo server.
Starting the Group 3 Test
To run the Group 3 test on a 3C592 EISA adapter, follow these
steps:
1 Start the Configuration and Diagnostic Program.
This program must be on the computer containing the
adapter you want to test.
2 Select Test Setup from the Test menu.
3 Select Group 3 from the Group Select box.
Table 5-1 Diagnostic Programs
Diagnostic
Program Name
Adapter in the Echo Server
3C503.EXE EtherLink II  or II TP, EtherLink II/16 or II/16 TP
3C505.EXE EtherLink Plus

3C507.EXE EtherLink 16 or EtherLink 16 TP
3C5X9CFG.EXE EtherLink III family
3C523.EXE EtherLink/MC
3C523TP.EXE EtherLink/MC TP
3C527.EXE EtherLink/MC 32
3C59XCFG.EXE EtherLink III EISA, EtherLink III PCI, Fast EtherLink
PCI, and Fast EtherLink EISA