Transcend Information III - Manual (Page 38)

Loading NetWare ODI Drivers 4-7
If you experience problems that occur only when using the
AutoLink program, display or print the AUTOLINK.LOG file.
The AUTOLINK.LOG file contains a log of all the events that
occurred during the AutoLink installation and configuration
process.
a To display the file, type:
type autolink.log | more
b To print the file, type:
print autolink.log
7 When the auto installation process is finished, remove the
diskette and reboot the computer.
When you do this, the computer will boot as a NetWare DOS
ODI client.
This concludes the procedure for installing a single adapter in
a NetWare DOS ODI client using the AutoLink feature.
Multiple Adapters in a Client
You can install multiple EISA adapters when you initially set up
your EISA computer, or you can add a second EISA adapter to a
computer in which a single adapter was previously installed.
In either case, you must run the EISA configuration program
as an integral part of the EISA adapter installation procedure.
Use multiple adapters in a client only if you plan to run
multiple protocols. For information on running multiple
protocols, refer to the documentation accompanying your
operating system.
Before proceeding, make sure you know each adapter’s slot
number. Refer to the next section, “Finding the Adapter’s Slot
Number.”
You must use the adapter’s slot number when installing one
or more adapters in a client.You must use the adapter’s port
address when installing one or more adapters in a server.