Transcend Information III User Manual
Page 41
4-10
C
HAPTER
4: L
OADING
N
ETWORK
D
RIVERS
2 Select
Configuration/Diagnostic/Troubleshooting, and press
[Enter].
3 Select
Configuration and Diagnostic Program and press
[Enter].
4 The next screen lists the installed adapters. Write down
their slot numbers.
5 Exit the program.
If you are using an ODI driver with multiple adapters already
installed and you have not updated the NET.CFG file, specify
which adapter you want the driver to recognize by adding
the slot number to the NET.CFG file using the SLOT XXXX
parameter, where XXXX is the slot number.
One Adapter in a Server
If you are running NetWare and have installed a single adapter
in an EISA computer that is functioning as a server, follow the
instructions in this section to load the NetWare 4.x server
driver.
The 3C59X EtherDisk diskette contains a NetWare 4.x server
driver (3C59X.LAN) and the NetWare Loadable Modules
(NLMs) that enable the NetWare 4.x driver to be used with
NetWare 3.11, 3.12, or 4.0x software. These files are found in
the subdirectories in the \NETWARE subdirectory.
Driver Installation with NetWare
To load the 4.x server driver, follow these steps:
1 Copy the contents of the appropriate \NETWARE\SERVER
subdirectory to the boot partition of the server’s hard disk.
The 3C59X EtherDisk diskette contains the NetWare 4.x server
driver and the NetWare Loadable Modules (NLMs) that enable
the NetWare 4.x driver to be used with NetWare 3.11, 3.12,
4.0x, or 4.1 software.