Transcend Information III - Manual (Page 39)

4-8 C HAPTER 4: L OADING N ETWORK D RIVERS
If you are running NetWare and you have installed multiple
3C592 EtherLink EISA adapters in an EISA-compliant computer,
follow these steps to install the NetWare ODI client driver:
1 Make sure your computer is turned off. Install the first
adapter.
2 Connect the network cable to the adapter.
3 Insert the EISA configuration utility diskette and turn on
the computer.
4 Run the EISA configuration program.
5 When the program has finished:
a Save the configuration.
b Remove the EISA configuration diskette and exit the
program.
c Restart the computer.
6 Insert the EtherDisk diskette and run the AutoLink program.
Refer to the sections “AutoLink Requirements” and “AutoLink
Installation” earlier in this chapter for instructions.
7 When the AutoLink installation is complete, remove the
diskette, reboot the computer, and physically connect it to
the server if you have not already done so.
8 Turn off the computer, install the second adapter, and
connect the network cable to the adapter.
9 Insert the EISA configuration utility diskette and turn on
the computer.
10 Run the EISA configuration program.
11 When the program has finished:
a Save the configuration.