Toshiba 50HM66 - Manual (Page 22)

22
HM66 (E/F) Web 213:276
Chapter 4: Setting up your TV
Viewing the system status
To view the system status:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T. A new set of
Installation menu icons will appear on-screen, as shown
below right.
3
Open the System Status menu, highlight System
Information, and press T.
4
Press C c to scroll through the menu bar to check the
Product Information and Software Version.
To close the screen and return to the Installation
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
Restore Factory Defaults
To restore all settings and channels to their factory
default values:
1
Follow steps 1–3 above.
2
Press C c to scroll through the menu bar to select
Factory Defaults.
3
Enter your PIN code (or 0000 if no PIN code has been set).
4
Highlight Yes and press T. The TV will turn off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug it in again to
complete the restore process.
To cancel the reset:
Highlight No and press T.
Note: If you have previously set the TV to High Bright mode,
and have restored Factory Defaults, the TV will default to Low
Power mode. To set the TV back to High Bright mode, see
page 42.
CH RTN ENTER EXIT Navigate Select Back Exit CH RTN ENTER EXIT Navigate Select Back Exit
System Infomation
System Status
Installation
Sleep Timer
ColorStream HD1 Audio
Setup
HDMI 1 Audio Auto
Auto
No
ColorStream HD2 Audio No
On
HDMI 2 Audio
Quick Restart
System Information
Done
Brand:
Model:
Toshiba
50HM66
Product Information
System Information
Done
2.2.26.0
Jan 24 2006 - 11:04:47
FW: 17
Software Version
System Information
Press YES to confirm. After the TV
turns off, unplug it and plug it back
in to complete the reset.
Yes No
HM66_EN.book Page 22 Thursday, February 23, 2006 2:49 PM