Toshiba 50HM66 - Manual (Page 16)

16
HM66 (E/F) Web 213:276
Chapter 4: Setting up your TV
Selecting the menu language
You can choose from three different languages (English,
French and Spanish) for the on-screen display of menus and
messages.
To select the menu language:
1
Press Y and open the Preferences menu.
2
Highlight Menu Language and press c.
3
Press B or b to select your preferred menu language and
press T.
4
Press O to close the Preferences menu.
Configuring the antenna input
sources for the ANT 1 and ANT 2
terminals
To configure the ANT 1 and ANT 2 input sources:
1
Press Y and open the Setup menu.
2
Highlight Installation and press T. (A new set of
Installation menu icons will appear on-screen, as shown
in step 3 below.)
3
Open the Terrestrial menu, highlight Input
Configuration, and press T.
4
Press B or b to highlight ANT 1, and press C or c to
select the input source (Cable or Antenna) for the
ANT 1 input on the TV.
5
Press b to highlight Antenna 2 in and then C or c to select
the input source (Cable or Antenna) for the ANT 2
input on the TV, if applicable. If you have not connected
anything to the ANT 2 input, skip this step.
6
To save your new settings, highlight Done and press T.
To revert to your original settings, highlight Cancel and
press T.
CH RTN ENTER EXIT Navigate Select Back Exit
Channel Browser Setup
English
Français
Español
Favorite Channels
Closed Caption Mode Off
Closed Caption Advanced
Input Labeling
Menu Language English
Preferences
CH RTN ENTER EXIT Navigate Select Back Exit
Installation
Sleep Timer
ColorStream HD1 Audio
Setup
HDMI 1 Audio Auto
Auto
No
ColorStream HD2 Audio No
On
HDMI 2 Audio
Quick Restart
CH RTN ENTER EXIT Navigate Select Back Exit
Terrestrial
Input Configuration
Channel Program
Channel Add/Delete
Signal Meter
Input Configuration
Antenna 1 In
Antenna 2 In
Cable
Antenna
Cancel Done
HM66_EN.book Page 16 Thursday, February 23, 2006 2:49 PM