F007, F008 – Toshiba H9 User Manual
Page 87
H9 ASD Installation and Operation Manual
79
Type Reset
Program
⇒
Utilities
This feature assists the user when performing fault analysis or by allowing a
quick system setup change when required. Performing a Type Reset results in
one of the following user-selected post-reset configurations.
Settings:
0 — None
1 — 50 Hz Setting
2 — 60 Hz Setting
3 — Reset to Factory Settings
4 — Clear Past Trips
5 — Clear Run Timer
6 — Initialize Typeform
7 — Save User Settings
8 — Restore User Settings
9 — Clear Cumulative Fan Timer
10 — Accel/Decel Time Setting 0.01 – 600.0 Seconds
11 — Accel/Decel Time Setting 0.1 – 6000.0 Seconds
12 — Update EOI Firmware
13 — Set EOI Memory to Default
14 — Save User Settings to EOI
15 — Restore User Settings from EOI
Direct Access Number — F007
Parameter Type — Selection List
Factory Default — None
Changeable During Run — No
Forward/Reverse Run Selection
Program
⇒
Fundamental
⇒
Standard Mode Selection
While operating using the keypad (
is set to EOI Keypad) this parameter
sets the direction of motor rotation. This setting may be changed during
operation. This setting will not override parameter
(Forward/Reverse
Disable).
If either direction is disabled via parameter
, the disabled direction will not
be recognized if commanded by the keypad. If both directions are disabled via
parameter
, the direction command from the keypad will determine the
direction of the motor rotation.
Settings:
0 — Forward
1 — Reverse
2 — Forward (EOI-switchable F/R)
3 — Reverse (EOI-switchable F/R)
Direct Access Number — F008
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — Yes
Reset