Toshiba WX800U - Manual (Page 48)

48
Chapter 6: Basic features
Setting Blue Screen
When Blue Screen is set to On, the screen will turn blue
and the sound will be muted when no signal is received.
1 Y > PREFERENCES > Blue Screen.
2
Press C or c to select On. Press O.
Note: Some external inputs may not mute the sound.
Adjusting POWER LED’s Dimmer
You can turn down the POWER LED's brightness.
1 Y > PREFERENCES > POWER LED Dimmer.
2
Press C or c to select On. Press O.
Note: This operation is available only in 2D viewing mode.
Displaying TV status information
To display TV status information:
Press .
The following information will display (if applicable):
•Current input (ANT/CABLE, Video, etc.)
•If ANT/CABLE is the current input, either “CABLE”
(for cable TV) or “ANT” (for over-the-air broadcasts).
•Channel number (if in ANT/CABLE mode)
•Input label (if set)
•Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
•Stereo, Mono or SAP audio status (when HDMI input
mode, PCM)
•Video resolution
•Aspect ratio of incoming video signal (4:3 or 16:9)
•V-Chip rating status
•GameTimer (if set)
•Current display mode (Side by Side, Top and Bottom,
or Frame Packing)
•Current display format (3D or 3D to 2D)
•Input video format (3D is displayed when video
format is 3D.)
To close the screen:
Press
again.
The following additional information (only available
for ANT/CABLE input) will display for off air digital
channels (if applicable):
•Title
•Duration
•Detailed description
To display next program information for digital
channels, press
again. Pressing a third time will
remove the entire banner.
Note: The location of the banner can be moved to the top
or bottom of the screen by pressing B or b while the INFO
display is onscreen. The last position will be stored to
memory.
2-2
ANT
Nashville WX Channel
Nashville WX Channel provides Middle Tenessee and Southern Kentucky
weather.
8:59am - 4:59pm EST
16:9 NONE 3D SVGA
3D to 2D Side by Side
WX800U_EN.pdf 48 2010/08/11 10:14:52