Toshiba WX800U - Manual (Page 45)

45
Chapter 6: Basic features
Using the HDMI ® settings feature
Note: If some HDMI legacy sources do not work properly
with your HDMI TV, set the following options (Content Type
and INSTAPORT
™ ) to Off. Adjusting these settings should
allow your HDMI legacy source to operate properly with
your TV.
The HDMI settings (Content Type and RGB Range)
need proper HDMI source devices. If your HDMI
source device does not support these features, the TV
may not work properly when these features are
enabled.
Note: If your HDMI connection is capable of 1080p and/or
your TV is capable of refresh rates greater than 60 Hz, you
will need a High Speed HDMI
® cable. Conventional HDMI/
DVI cables may not work properly with this mode.
1
Select the appropriate HDMI input mode (HDMI 1,
HDMI 2, HDMI 3, or HDMI 4).
2 Y > PREFERENCES > AV Connection > .
3
Press B or b to select HDMI Settings.
4
Press B or b to select an item.
5
Press C or c to select a setting.
Setting the HDMI ® audio mode
1 Y > PREFERENCES > AV Connection > .
2
Press B or b to select HDMI 3 Audio or HDMI 4
Audio
.
3
Press C or c to select Auto, Digital or Analog.
Note:
• HDMI 3 Audio is set to Digital when Rear Shared Audio
is set to ColorStream HD1 or Video 1 (- p. 31).
• HDMI 4 Audio is set to Digital when Side Shared Audio
is set to PC or ColorStream HD2 (- p. 31).
Viewing the HDMI ® signal
information
1 Y > PREFERENCES > HDMI Information
Display
.
2
Press C or c to select On. Press . Normal banner
and signal information banner appears.
Note:
• Signal information banner will appear when this feature
is set to On and you watch HDMI input.
• If you press when this feature is set to Off, only
normal banner will appear.
• When Content type is No Data, this is not displayed.
Mode (default setting) Description
Enable Content
Type: On
Adjusts the picture quality
automatically by the content of
“Contents type” included in the
HDMI input.
Note:
When Picture Mode is set to
AutoView , this feature is available.
INSTAPORT ™ : On
Reduces the lag time when
switching HDMI sources.
RGB Range: Auto
Adjusts RGB full range signal
automatically.
When Limited is selected, RGB
output signal is output in the range
from 16 to 235. When Full is
selected, RGB output signal is
output in the range from 0 to 255.
O K
Mode Description
Auto
When viewing the HDMI 3 input or
HDMI 4 input, if digital audio from the
HDMI input is available, it will be
output. If not, the TV detects and
outputs analog audio from each Audio
input.
Digital
When viewing the HDMI 3 input or
HDMI 4 input, digital audio from the
HDMI input will be output.
Analog
When viewing the HDMI 3 input or
HDMI 4 input, analog audio from each
input will be output.
O K
WX800U_EN.pdf 45 2010/08/11 10:14:52