Form tear-off, Line spacing, Skip over perforation – Oki 391 User Manual
Page 72: Bottom feed, Rear feed, Perforation, skip over
72
Microline 390/391 Turbo
|
Menu Settings Table (Continued)
For a complete explanation of each menu item, refer to “Using Your Printer, Menu Mode, Explanations of Menu Items.”
The table below shows the items which may appear in the menu. Settings which are engaged at the factory (defaults) are set in
bold italic. Some groups or entries will only appear when a specific emulation is engaged, as noted.
Group
Item
Settings (Defaults are set in bold italic)
Rear Feed
Line Spacing
6 LPI, 8 LPI
Form Tear-Off
Off, 500 ms, 1 sec, 2 sec
Skip Over Perforation
No, Yes
Page Width (wide model only)
13.6", 8"
Page Length
11", 11-2/3", 12", 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5"
Bottom Feed
Line Spacing
6 LPI, 8 LPI
Form Tear-Off
Off, 500 ms, 1 sec, 2 sec
Skip Over Perforation
No, Yes
Page Width (wide model only)
13.6", 8"
Page Length
11", 11-2/3", 12", 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5"