Using your printer, Top of form (tof), Top of form – Oki 391 User Manual
Page 40: Using your printer 0
40
Microline 390/391 Turbo
|
Top of Form sets the print start position for the printer. It is
adjustable in increments of 1/144 of an inch. The amount of
adjustment is limited to avoid paper jams.
The first line prints at the red line of the plastic paper shield
(1) on the printhead.
32T-18.eps
M
Using Your Printer
1
Top of Form (TOF)
!
If you turn the platen knob when the printer is turned
on, you will cause the Top of Form to mis-align. Always
turn the printer off before turning the platen knob!
!
The factory default setting for the Top of Form (where
the printing should begin) is one inch down from the top
of the page.
!
Your software may print the first line of print above or
below where TOF is set. You may need to adjust the
TOF to meet your software’s needs. Use the procedures
in “Using Your Printer, Top of Form, Forms Tear-Off
Status (ON or OFF).”