Onkyo PR-SC5508 - Manual (Page 53)

53
En
Audyssey DSX™
■
Soundstage
` –3dB to Reference to +3dB
With this setting, you can adjust the soundstage when using
Audyssey DSX™.
Note
• If the “Center” setting is set to “None”, or both “Front High”
and “Front Wide” settings are set to “None” ( ➔ 48), this setting
cannot be selected.
Theater-Dimensional
■ Listening Angle
` Wide:
Select if the listening angle is greater than 30
degrees.
` Narrow:
Select if the listening angle is less than 30 degrees.
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an
angle close to one of the two available settings.
LFE Level
■
Dolby Digital *1 , DTS *2 , Multich PCM, Dolby
TrueHD, DTS-HD Master Audio, DSD *3
` – dB, –20dB, –10dB, or 0dB
With these settings, you can set the level of the LFE (Low
Frequency Effects) channel individually for each input
sources.
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to “–20dB”
or “–
dB”.
*1 Dolby Digital and Dolby Digital Plus sources.
*2 DTS and DTS-HD High Resolution Audio sources.
*3 DSD (Super Audio CD) sources.
Direct
■
Analog
Subwoofer
` Off:
Analog audio signals (bass signals) are not output.
` On:
Analog audio signals (bass signals) are output.
This setting determines whether or not analog audio sig-
nals (bass signals) are output from front speakers when the
Pure Audio or Direct listening mode is selected.
Note
• If the “Subwoofer” setting is set to “No” ( ➔ 48), this setting
cannot be selected.
■
DSD
DAC Direct
`
Off:
DSD signals are processed by the DSP.
`
On:
DSD signals are not processed by the DSP.
This setting determines whether or not DSD (Super Audio
CD) audio signals are passed through the DSP for A/V
Sync, delay, etc., processing when the Pure Audio or
Direct listening mode is selected.
Note
• Once you have selected “On”, only DAC Direct will be available
for selection.
Items can be set individually for each input selector.
Main menu Source Setup
Audyssey
When Audyssey MultEQ ® XT32 Room Correction and
Speaker Setup is complete, the “Equalizer” (
➔ 50) will
be set to “Audyssey” and the “Dynamic EQ” will be set
to “On”.
■ Dynamic EQ
` Off:
Audyssey Dynamic EQ ® off.
`
On:
Audyssey Dynamic EQ on.
The Dynamic EQ indicator will light (
➔
9).
With Audyssey Dynamic EQ, you can enjoy great
sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deterio-
rating sound quality as volume is decreased by taking
into account human perception and room acoustics. It
does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the
content sounds the way it was created at any volume
level — not just at reference level.
Front left speaker Front right speaker
Listening angle: 30°
Source Setup
Preparation
Press the input selector buttons to select an input source.