Onkyo PR-SC5508 - Manual (Page 44)

44
En
Explanatory Notes
Main Menu Input/Output Assign
Monitor Out
On the “Monitor Out” settings, you can select whether or
not to have the video sources’ images output through the
HDMI output, as well as whether to have the onscreen
setup menu output through the HDMI output or through
an analog output.
If you connect your TV to HDMI output, “Monitor Out”
setting is automatically set so that the onscreen setup
menus are displayed and composite video, S-Video, and
component video sources are upconverted
* and output.
If you connect your TV to the COMPONENT VIDEO
MONITOR OUT (not the HDMI output), “Monitor Out”
setting is automatically set so that the onscreen setup
menus are displayed and composite video and S-Video
sources are upconverted
* and output.
Note
• See “Video Connection Formats” ( ➔ 23) for charts showing
how the “Monitor Out” and “Resolution” settings ( ➔ 45)
affect the video signal flow through the AV controller.
■ Monitor Out
` Analog:
Select this if your TV is connected to the COMPO-
NENT VIDEO MONITOR OUT, MONITOR OUT
S, or MONITOR OUT V.
`
HDMI Main:
Select this if your TV is connected to the HDMI
OUT MAIN.
` HDMI Sub:
Select this if your TV is connected to the HDMI
OUT SUB.
`
Both:
Select this if your TVs are connected to the HDMI
OUT MAIN and HDMI OUT SUB. Video signals
are output from both HDMI outputs at the resolution
supported by both TVs.
` Both(Main):
Select this if your TVs are connected to the HDMI
OUT MAIN and HDMI OUT SUB. Video signals
are output from both HDMI outputs but HDMI OUT
MAIN will become a priority; depending on the reso-
lution, video signals may not be output from HDMI
OUT SUB.
` Both(Sub):
Select this if your TVs are connected to the HDMI
OUT MAIN and HDMI OUT SUB. Video signals
are output from both HDMI outputs but HDMI OUT
SUB will become a priority; depending on the reso-
lution, video signals may not be output from HDMI
OUT MAIN.
Note
• If not connected to the same output you have selected in the
“Monitor Out” setting, the “Monitor Out” setting will be auto-
matically switched to “Analog” (
➔ 24).
• When you select other than “Analog”, the onscreen setup menus
are output by only the HDMI output. If you’re not using the
HDMI output and select settings by mistake and the menus
disappear, press AV controller’s
MONITOR OUT to select
“Analog”.
• For Deep Color output, if the “Monitor Out” setting is set to
“Both(Main)” or “Both(Sub)”, the number of bit may be lim-
ited due to the capability of your TV connected to a priority out-
put.
Changing “Monitor Out” setting manually
Input/Output Assign
Menu selection
Setting target
Setting options (default setting underlined)
Main Menu Speaker Setup
■
Subwoofer
` 1ch:
Audio signal is outputted from SW1 jack
only.
` 2ch:
Audio signal is outputted from SW1 and
SW2 jacks.
IN
OUT
Composite video, S-Video,
component video
Composite video, S-Video,
component video
HDMI
HDMI
IN
OUT
Composite video, S-Video
Composite video, S-Video
Component video
Component video
1
Press MONITOR OUT on the front panel.
The current setting is displayed.
2
Press MONITOR OUT on the front panel
repeatedly to select:
`
Analog, HDMI Main, HDMI Sub, Both,
Both(Main) or Both(Sub)