Oregon Scientific SE120 - Manual (Page 4)

EN
4
GETTING STARTED
UNPACKING THE WATCH
When you unpack your Heart Rate Monitor Watch,
make sure to keep all the packing materials in a safe
place, in case you need to later transport or return the
product for servicing.
In this box, you will find:
• Watch
• Chest belt
• Mounting bracket
• 2 x CR2032 lithium batteries
NOTE Do not dispose this product as unsorted
municipal waste. Collection of such waste separately
for special treatment is necessary.
BATTERIES
2 x CR2032 lithium batteries – one for the watch
and another for the chest belt – both are already
installed. The batteries typically last one year. We highly
recommend that you contact the retailer or our
customer service department if you need to replace
them.
shows when the battery is low.
To replace the watch battery:
1. Turn the watch over so that
you are looking at the back
plate.
2. Disconnect the watchstrap as
shown.
3. Using a small screwdriver,
remove the four screws
that hold the back plate into
position.
4. Remove the back plate and
set it aside.
5. Using a thin blunt instrument,
hook the release catch and
lift the clip.
6. Remove the old battery.
7. Insert new battery with + side
facing upwards.
8. Replace the battery clip.
9. Reset the watch by inserting
a thin metal instrument into
the reset hole.
10. Replace the back plate and
screws.
SE120_M_EN_R7 2006.4.12, 10:53 AM 4