RCA RCU900 - Manual (Page 18)

1 8
Learn Commands (continued)
11. To save and exit from the Learn routine, press and release the
LCD OK key. The touchscreen returns to the Main
Setup Screen.
12. The Learning process is now complete.
13. Press LCD CLEAR on the Main Setup Screen to exit
Setup Mode.
Note: Learned keys will beep twice when pressed if keypress
beep is turned on.
Clear All Stored Learned Commands
Under a Mode
If you want to clear all of the Learning commands under one
mode, such as TV, VCR or DVD, follow these steps:
1. Press and hold the SETUP key on
the rubber keypad until the LED
indicator light remains on and the
touchscreen shows the Main
Setup Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and release the LCD LEARN
key. The LED indicator light blinks
once to indicate acceptance of
the keypress.
4. The touchscreen now shows the
Device Setup Screen. Press and
release the device key on the rubber
keypad for the mode commands you
want the RCU900 to clear (TV, VCR,
SAT/CBL
, etc.). The LED indicator
light blinks once to indicate
acceptance of the keypress.
5. The touchscreen now shows the
Learn Setup Screen 1. Press and hold
the SETUP key until the Main Setup
Screen is displayed. All Learned
commands that were previously
stored under that mode are
now cleared.
6. Press LCD CLEAR on the Main
Setup Screen to exit Setup Mode.
Master Clear
Clearing all stored Learned commands is recommended before
first-time Learning. To clear all Learned commands, follow
these steps:
1. Press and hold the SETUP key on
the rubber keypad until the LED
indicator light remains on and the
touchscreen shows the Main Setup
Screen. This process takes
approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and hold the LCD LEARN key
until the Main Setup Screen is
displayed. This process takes
approximately 5 seconds.
RCU900_IB_revC.qxp 12/19/02 9:50 AM Page 18