RCA RCU900 - Manual (Page 17)

Learn Commands
Now you’re ready to have your RCU900 learn the commands
from your existing remotes. All Learned keys are saved
automatically. Remember, only one original remote can be stored
under any one mode. The RCU900 can learn the commands for
one TV remote, one VCR remote, one DVD remote, etc.
1 7
1. Point the top of the original remote at
the base of the RCU900 so the IR
LED on the original remote is in line
with the RCU900 Learning sensor,
located at the bottom of the remote.
The remotes should be positioned
two to three inches apart.
2. Press and hold the SETUP key on
the rubber keypad until the LED
indicator light remains on and the
touchscreen shows the Main Setup
Screen. This process takes
approximately 2-3 seconds.
3. Release the SETUP key.
4. Press and release the LCD LEARN
key. The LED indicator light blinks
once to indicate acceptance of
the keypress.
5. The touchscreen now shows the
Device Setup Screen. Press and
release the device key on the rubber
keypad that corresponds to the
remote you want the RCU900 to
learn (TV, VCR, SAT/CBL, etc.). The
LED indicator light blinks once to
indicate acceptance of the keypress.
6. The touchscreen now shows the
Learn Setup Screen 1, which displays
the current screen keys for the mode
you have chosen. The LCD SETUP
MACRO
and LEARN keys are
also shown.
7. Press and release the key on the
RCU900 to be taught. (Remember:
You can switch between the screens
displayed by pressing the LCD
SCREEN
key.) The LED indicator
light blinks once to indicate
acceptance of each keypress.
8. Now, press and hold the key on
the original remote until the LED
indicator blinks once and the
touchscreen shows Learn Setup
Screen 2. This process takes
2-3 seconds to complete.
9. To learn another key, press and
release the LCD LEARN key and
repeat from Step 7.
10. If a problem occurs with the
Learning process, the LED indicator
light flashes for two seconds and
you hear three beeps, but the unit
remains in the Learn routine with
Learn Setup Screen 1 displayed.
Repeat from Step 6.
RCU900_IB_revC.qxp 12/19/02 9:50 AM Page 17