beautypg.com

Input names, Remote control, Pre l iminar y – Runco QUANTUM Q-750D User Manual

Page 83

background image

Operation

Q-750d Series Installation/Operation Manual

67

PRE

L

IMINAR

Y

Input Names: You can give each DHD Controller input a descriptive name. For example,
you may want to change the default input name to the type of source component
connected to it: “VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12
characters long.

To edit an input name, select Input Names from the Service menu. Press

or

to select

an input and press ENTER. Use the

or

buttons to change a character; press

or

to select a character to change. When you have finished editing the input name,

press ENTER or MENU.

To restore the default input name, press

repeatedly to highlight that input name in the

“Restore” column. Then, press ENTER.

Remote Control: Select Remote Control from the Service menu to change the following
settings related to remote control operation.

Remote Code: Select Remote Code from the Remote Control menu to set the

infrared (IR) code set to which the DHD Controller will respond. By default, it is set to
17. You can change this setting if either:

• Another device in the theater (a DVD player, for example) is responding to

commands from the DHD Controller remote control (Figure 2-5) in ways that are
unpredictable or undesirable.

• You have multiple DHD Controllers and want to control them independently, as

opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or,
you can use a single remote and change the IR code as needed to address a
specific DHD Controller.

When you change a remote code on the DHD Controller, you must re-program the
DHD Controller remote control to send that same code. To do this:

1. Press and hold the LIGHT button on the

remote control for approximately three
seconds, or until the LED on the remote lights
solid red.

2. Enter a new two-digit code between 00 and 31

inclusive. Include a leading zero for single-digit
codes; for example, enter 9 as “09.”

3. The LED turns off to confirm the code change. If you enter an invalid code, the LED

flashes for three or four seconds. Try again, entering a valid code.

COMP Key Source: Select COMP Key Source from the Remote Control menu to

assign the COMP remote control button to either the Component or SCART input.

Input Names

Restore

C o m p o s i t e

Composite

S - V i d e o

1

S-Video 1

S - V i d e o

2

S-Video 2

C o m p o n e n t

Component

H D

1

HD 1

H D

2

HD 2

S C A R T

SCART

H D M I

1

HDMI 1

H D M I

2

HDMI 2

Use the DHD Controller front-panel keypad to change the IR code to
which the controller will respond. Then, change the code sent by the
remote to match as described below.

Tip

EXIT

RETURN