2 q-750d rear panel, Figure 2-2 . q-750d rear panel, Q-750d rear panel – Runco QUANTUM Q-750D User Manual
Page 22: 2. q-750d rear panel, Pre l iminar y
6
Q-750d Series Installation/Operation Manual
PRE
L
IMINAR
Y
• FRONT IR SENSOR
Receives infrared signals from the remote control unit.
• EXHAUST VENT
Warm air exits the projector through this vent. Ensure that it is not blocked.
• STATUS LED
Indicates projector status as follows:
• Solid green = AC power present, ready to turn on.
• Flashing green = Projector is initializing; keypad functions not allowed.
• Off = Normal operation.
• Flashing red = Over temperature, user intervention (clear vents, turn on AC) may fix
problem
• Solid red = Error that requires servicing (fan failure, Power-on Self-Test (POST)
failure).
2.2
Q-750d Rear Panel
Figure 2-2 shows the Q-750d rear panel.
Figure 2-2. Q-750d Rear Panel
1.
RS-232C INPUT (9-pin, female D-Sub)
Connect the Display Control output on the DHD Controller to this input (see Figure
2-4).
2.
DHD INPUT
An HDCP-compliant digital video input for connecting the HDMI output from the DHD
Controller.
3.
POWER INPUT (100 to 240 VAC)
Connect the Q-750d to power here.
RS-232
RS-232
DHD INPUT
DHD INPUT
AC
AC
2
3
1