Remove projector front feet, Install ceiling mount adapters/projector stands, Pre l iminar y – Runco QUANTUM Q-750D User Manual

Page 39

Text mode
Original mode

Q-750d Series Installation/Operation Manual

PRE

IMINAR

Remove Projector Front Feet:

Place the projector upside down on a
blanket or other soft surface. Loosen
and remove the two front feet on the
projector.

Install Ceiling Mount Adapters/Projector Stands: For ceiling installations, these
brackets bring the mounting points for the projector mounting plate (included with the
projector ceiling mount kit) from the bottom of the projector up and around the AutoScope
lens motor housing. For floor installations (where the projector is upright), the adapters
allow the projector to lie flat on the mounting surface.

Using six (6) each of the supplied, M6 x 12mm Pan-Head Phillips screws (item #2), attach
the AutoScope Ceiling Mount Adapters/Projector Stands (items #3 and #4) to the
projector as shown in Figure 3-7.

Remove