Runco QUANTUM Q-750D - Manual (Page 30)

Installation
14 Q-750d Series Installation/Operation Manual
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the Q-750d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 15
2
Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional) 21
3 Mount the projector 28
4 Connect the DHD Controller to the projector 29
5 Connect signal sources to the DHD Controller 31
6 Connect external controller to RS-232 port (optional) 36
7
Connect 12-volt trigger outputs to AutoScope lens motor
and/or other equipment (optional) 37
8
Connect projector, DHD Controller and lens motor (if
present) to AC power and power up 39
9
Primary lens adjustments: projected image size (zoom),
position (shift) and focus 18, 40
10
For rear-screen and/or ceiling-mount installations, select
the proper picture orientation 40
11 Install CineWide anamorphic lens (optional) 41
12
CineWide lens adjustments: position, pitch (angle),
geometry and focus 41
13
Display calibration: adjust the following for each input and
display mode (resolution and frame rate); save settings
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance 49